USB-SC09 cable programming manuals

overview:

USB-SC09 through the USB interface and RS422 serial connection signal converter cable programming, computer-driven control of the operation, the computer''s USB port into a simulation of traditional serial port (commonly known as the COM port) in order to use Existing programming software, communications and software applications such as monitoring software. The work of the power cable from the USB port, no longer by the PLC programming port power supply, converter box on the two-color LED instructions state to send and receive data.

USB-SC09 cable programming apply to the entire Mitsubishi FX Series PLC and A series PLC, and FX-232AW alternative communications module, the largest communications support for the 2 km distance.

USB-SC09 cable structure form:

characteristics and technical indicators:

• support for USB-SC09 operating system: Windows2000/Windows XP (WinNT4 / 95/98/Me/DOS does not support)

• support for USB-SC09 version of the software programming: FXGP / WIN V1.0, GPP V4.0, GX Developer V7.0 and above

• fully compatible with USB V1.1 and USB CDC V1.1 specification

• USB bus-powered, the current consumption of about 50mA

• Baud rate: 300bps ~ 1Mbps automatically adapt to the standard rate

• support for the UART data format: data bit: 7, 8, stop bit: 1, 2, parity bit: odd / even / no parity

• support the long-distance communications, the largest communications from the 2 km (9600bps time)

• each PC only supports a USB cable programming

• Operating Temperature: -20 ~ 75

• Cable length: 3 m, color: black

use:

USB-SC09 cable programming will need to install USB device drivers to use these drivers are included in the sale of products with the CD-ROM, a look at ways to install the driver on the CD-ROM documentation, will not go into here.

driver installation is complete, in the Windows Device Manager will appear in USB-SC09 cable programming corresponding to the COM port, just in the programming of software or other applications to select the COM port to the other parameters of the use of communications The default setting, followed by the use of traditional RS232 port with the cable programming exactly the same.

Note: You can not use the RS422 side DB25M plug and plug MD8M.

long-distance communication:

USB-SC09 cable programming PLC and the largest distance communications of up to 2 kilometers (9600bps), users need to press the self-made plans to extend the cable, communications lines used for the cross-sectional area of 0.22mm2 over unshielded twisted pair. More than 2000 meters away when the RS422 line in the installation of repeater (model: E485GA, four electronic products) to extend the communication distance.

Note: You can not extend the USB interface cable.

as a result of USB-SC09 and PLC Internal resistance terminals have been installed, so when the need for external wiring subsequent termination.