in NT4 install SCSI hard drive, there are two circumstances: 1. SCSI system to be installed on the hard disk 2. the system has been installed, coupled with the need for a SCSI hard drive.

1. First of all, need to do a disk drive. Rocky3782EVS using Symbios53c1010-33's SCSI chipsets, and its accompanying CD-ROM drive in the middle. The path is as follows:
\ SCSI \ Symbios \ 53c1010-33, this is a compression program, or Winzip be WinBar decompression after use (which can extract the hard drive or floppy disk). Decompression after the path Keep in mind that (his best Specify a directory). Decompression after the driver for a number of operating systems, NT directory selection, will Kaoru driver floppy disk, make a disk drive.

2. In the first case to be installed at the WinNT Setup screen to install blue screen when the switch by F6 keys until a special screen installed equipment in the conduct of the SCSI device is installed, do a good job to insert the disk drive, NT will recognize that SCSI models of controllers, according to<enter>continue, with the following general steps to install; otherwise the procedure will be prompted to install the "File system couldn't loading "can not continue the installation.

3. The second step in the installation of the following circumstances:
boot Self-test, detected two SCSI controller (onboard), if the hard disk has been put up at this time, it should be hard to detect.
suggested that the NT patch together.
into the system<My Computer> \ <Control Panel> \ <SCSI Adapter> \ <Drivers> \ <Add> \ <From to Disk>, insert the disk drive (or directly to the driver to extract the hard disk) to start Install the driver. After the completion of the installation process will be prompted to restart.
to restart the system after the<Disk Manager>found more than a hard disk, partition and format it to use this after a SCSI hard drive.